Jmayes.com!

{"from":"com.segway.robot.client","ACTION.SESSION_OPEN":"com.segway.robot.provision,ninebot,public,27.0.0-SNAPSHOT,12345678,26.1.0,com.segway.robot.host,12345678"} x,0A {"from":"com.segway.robot.client","ACTION.MESSAGE_LISTENER_READY&q...

There is actually not very many resources for Loomo Hackers on the net, I have Googled my eyes out and these are the only ones that have any meat to them, please contribute any other links that can be helpful. Official Segway Developer program https://developer.segwayrobotics.com/developer/overview....

I have had much success breaking down the protocol that the phone app uses to control Loomo. On the onset I want to say that I am uncomfortable with how much communication I see between the phone (and loomo) and the cloud servers, pretty much everything you do with loomo is logged. Going past that I...

So for the heck of it I tested the android system to see if there were any obvious holes. Sorry to say I did not find any. Where I can use ADB to gain access, there is no exec rights in any directories (that I have found). Chmod is locked out so no joy there. Also using adb (and command line) you ca...

There was another disappointment here in that the display would only come on during an "Event" or when you first plug it in, during regular operation is would be off and black. You are required you to hit a button to bring it on and check status by repeating the button push’s. Not so much ...

Available Plug in Interface Boards From Ebay and JmayesDeals.com

Basic Interface with no Driver $29.00
See in Store

Full Interface with RS232 Driver $39.00
See in Store

Hardware connections Net card connector (looking in the card box) (J2) 08642<–Pin #’s (0=10) xxxxx xxxxx 97541<–Pin #’s Net Card Connector To PC RS232 Connections J2 (UPS) Description J1 (to computer) 1 Gnd –>DB9p5 (GND) 2 input (to ups) –>DB9p3 (TX) 3 output (from ups) –>DB9p2 (RX) 4 V+ (12V) 5 (un...

CyberPower UPS Network card internal serial protocol Serial Setup: 2400 Baud, No Parity, 8 Bits, 1 Stop bit. (2400,N,8,1) Commands sent to the UPS must end with x0D (CR) Data responses start with “#” and end with x0D (CR) Basic UPS Commands Command to UPS (Add CR,x0D) Result T self test S(0x2E)1R999...

Serial Interfacing with a CyberPower UPS By Jeff Mayes, October 2018 Preface This all started when I decided we needed a UPS to integrate into our products and searched with the following criteria. Must be low cost, 300w, rack mounted, have batteries that load into the front and have a serial port. ...